cheep hp tricks for a 305

[murraygmc]

hay there folks ,
 iv got a stock 305 i just put in my truck and i was wandering if there was any cheep ( under 100 dollers )  tricks i could do to the engine to maby get some extra power out of it ......i plan on puting headers on it but is there any other tricks ?

thanks Matt .

[joedapper]

If you can find a crank and stroke it to 327 that should do it, somebody should have one somewhere you can get your hands on.  A bit more labor intensive than a bolt on but it will make a difference.   

[murraygmc]

ya thanks for that but id have to pull it back out and i dont realy want to do that at this time but thanks any way

Matt.

[Stewart G Griffin]

Deep xtra capacity oil pan with windage tray.

More ideas later.

Possibly the cheapest way not under $100 would be a 6-71 supercharger.  Put that in your pipe and smoke it, 305 haters.

More on this later, also.

[SUX2BU99]

Car Craft I believe it was did an article on a lame 165 HP 84 Camaro 305 and with just bolt ons they got 325 HP out of it. That was with a cam and head change though. The article is on the net somewhere.

[murraygmc]

thanks guys........if i ever do pull it a 350 will go back in

[Captkaos]

Without pulling it apart or updating parts there is nothing you can do that would warrant the cost.

[malibu795]

Without pulling it apart or updating parts there is nothing you can do that would warrant the cost.

x2

heads and cams are POS on these motors

[eventhorizon66]

Go with a full exhaust (since you'll use it on any future 350's), give her a good tune up, dial in as much ignition advance as she'll take, and start saving up for a 350.

[rick_c]

I had an 82 a few years ago, 305 motor...the only thing we did to it was a crane cam 100052 might have the part number wrong but its the energizer with .454" lift.274 duration I think.
It ran awesome, the first time I ran it hard I broke the trans bell housing ear to ear...so I call B.S. on anyone who says a 305 can't run...I finally spun a bearing racing a 350z...won the race...blew the motor...well worth it!!
BTW...factory intake exhaust heads etc...edel 1406 carb

Oh yea I took the esc distributor out and replaced it with a regular one and removed the advance weights and springs...