« previous next »
Pages: [1]   Go Down

Author Topic: Motors in.  (Read 2855 times)

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Motors in.
« on: November 14, 2010, 08:56:56 am »
Its in, it runs, still have to do a little tuning, and I have a noise coming from the bell housing area??






Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline fitz

  • Senior Member
  • ****
  • Posts: 2085
Re: Motors in.
« Reply #1 on: November 14, 2010, 12:37:02 pm »
Quote from: Blazin on November 14, 2010, 08:56:56 am
I have a noise coming from the bell housing area??

Throwout bearing?
What's the specs on the new motor you put in?
Logged

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Motors in.
« Reply #2 on: November 14, 2010, 02:37:25 pm »
Brand new through out bearing! I am going to investigate this week one night.
 Just a 350, new rings, bearings, hi volume oil pump, cloyes double roller chain, with RV cam, and an Edlbrock performer. It was built a long long time ago. Put about 500 miles on it, and the harmonic balancer fell off do to the bolt breaking. It mowed the end of the crank on one side of the key way. It sat in that truck for almost 14 years. I put a new key in it and filled in the crater in the crank with weld. Ground and filed it smooth so another balancer would fit, and called it good.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs
Pages: [1]   Go Up
« previous next »