« previous next »
Pages: 1 [2]   Go Down

Author Topic: painful heater core  (Read 10709 times)

Offline Layne

  • Senior Member
  • ****
  • Posts: 1023
Re: painful heater core
« Reply #15 on: February 18, 2011, 01:25:26 am »
Quote from: Dr_Snooz on February 13, 2011, 09:59:41 pm
That looks like a lot of fun. FWIW, the square body heater cores are a LOT easier. I think I did mine in about 2 hours. That included the time I spent blowing and scrubbing out all the dust in the vents.

I say if nothing rattles, then the screws were not needed.
Did the one in my 88-98 (88) In about 45 mins!!! 8)
Logged
77 c-10 - 77 400 86 700r4 "Emmy"
83 citation - 2.5L Four on the Floor!
88 sierra - reman 350 700r4 "Eleanor"
All normal practicality and rational money handling goes out of the window when it comes to my truck.

Offline bobcooter

  • Junior Member
  • ***
  • Posts: 788
  • 1979 Scottsdale C-20
Re: painful heater core
« Reply #16 on: February 20, 2011, 07:23:42 am »
That is completely retarded to build something like that. Engineers will NEVER have to work on anything they design. Making an engineer work on something he designed would be the ultimate revenge!
Logged
'79 C-20, 350/400, 3:73 gears, 9 leafs and a headache rack
Favorite Quote, "Good judgement comes from experience. Experience comes from poor judgement."

Offline Canadian 4X4

  • Frequent Member
  • **
  • Posts: 421
Re: painful heater core
« Reply #17 on: February 20, 2011, 03:59:40 pm »
That's worse than working on boats. I have been in some small places. took me a whole afternoon to change spark plugs on twin 454's.
Logged
Pages: 1 [2]   Go Up
« previous next »