« previous next »
Pages: [1]   Go Down

Author Topic: Column Shifter Install Problems  (Read 4128 times)

Offline TorchRed77Vette

  • Newbie
  • Posts: 7
Column Shifter Install Problems
« on: August 12, 2011, 06:09:28 pm »
So I bought a "Column Shifter Dress Up Kit" which turns out did not work for my truck (1978 C10) because it was "guaranteed to fit".  I knocked the pin out of my shifter to install the new shifter and surprise, it didn't fit.  When I pulled out the old shifter I heard springs clicking and sure enough now I can't reinstall the old shifter to where it works.   

Is there a trick to reinstalling these things without taking apart the whole steering column.  If not are there any good instructions for doing this?

Logged
1978 C10 Fleetside Short bed.  383 Stroker.
  ___________
 /''T''|[___|___]__
[---T--L -OlllllllO-]
()_)"""()_)/"**"\)_)

Offline beastie_3

  • Senior Member
  • ****
  • Posts: 3170
  • Josh
    • My truck pics
Re: Column Shifter Install Problems
« Reply #1 on: August 12, 2011, 07:00:24 pm »
I never had a issue installing mine. Knock out pin, take old lever out, install new lever, put pin back in.
Logged

Offline TorchRed77Vette

  • Newbie
  • Posts: 7
Re: Column Shifter Install Problems
« Reply #2 on: August 13, 2011, 02:39:18 pm »
I can get it reinstalled fine, but it just won't shift out of park when I do so.  Looks like I am stuck taking apart the whole column an seeing whats going on.  Can't do it in this heat though, truck might have to be parked for awhile.
Logged
1978 C10 Fleetside Short bed.  383 Stroker.
  ___________
 /''T''|[___|___]__
[---T--L -OlllllllO-]
()_)"""()_)/"**"\)_)
Pages: [1]   Go Up
« previous next »