« previous next »
Pages: [1]   Go Down

Author Topic: nv4500 k10 conversion..  (Read 3304 times)

Offline kdime

  • Newbie
  • Posts: 11
nv4500 k10 conversion..
« on: October 06, 2011, 06:48:06 pm »
will it bolt up to a np208 t-case or will i have trouble?
Logged
life sucks sometimes... you just have to take it in stride

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: nv4500 k10 conversion..
« Reply #1 on: October 06, 2011, 08:32:42 pm »
   I think you will need an adaptor, but with a nv4500 trans, your truck will shift way better.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline Edahall

  • Frequent Member
  • **
  • Posts: 311
Re: nv4500 k10 conversion..
« Reply #2 on: October 07, 2011, 11:48:50 am »
Be sure to put new synchro rings before installing the transmission.  Upgrade to brass ones if possible.  The 3rd gear syncro is most common to go out.
Logged
1990 ¾ ton 4x4 Chevy Suburban
-Cummins Diesel - 12 valve - factory rebuilt
-6 speed bullet proof manual transmission - NV5600
-Gear Vendors Overdrive
-Upgraded Holset HX-35 turbo
-NP205 iron transfer case
-3.73 gears
-2" Lift

Offline kdime

  • Newbie
  • Posts: 11
Re: nv4500 k10 conversion..
« Reply #3 on: October 10, 2011, 08:26:29 pm »
i think all i need is a bel housing and maybe flywheel? is there a diff. between vortec 350 and a regular 350?
Logged
life sucks sometimes... you just have to take it in stride
Pages: [1]   Go Up
« previous next »