« previous next »
Pages: [1]   Go Down

Author Topic: 345/35/18r Hoosier on 18x9.5 Boss 338  (Read 4842 times)

Offline elloco86

  • Newbie
  • Posts: 6
345/35/18r Hoosier on 18x9.5 Boss 338
« on: April 18, 2012, 11:26:42 pm »
Has anybody used these before. I got these on the rear of my 86 c10 and there a small rub on the inner fender well about an inch and a half. I was wondering if anybody ever used spacers.
Logged
Why build it if you can't drive it?

Offline elloco86

  • Newbie
  • Posts: 6
Re: 345/35/18r Hoosier on 18x9.5 Boss 338
« Reply #1 on: April 19, 2012, 11:58:13 am »
here are my 338 on hooiser's
Logged
Why build it if you can't drive it?

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18461
    • http://www.73-87chevytrucks.com
Re: 345/35/18r Hoosier on 18x9.5 Boss 338
« Reply #2 on: April 19, 2012, 12:03:40 pm »
The rub on the inside or outside?  I measure a long time ago and found you could fit a 14" wide tire in the back and not rub with the right backspacing.  I would run a quality set of wheel spacers.
Logged

Offline elloco86

  • Newbie
  • Posts: 6
Re: 345/35/18r Hoosier on 18x9.5 Boss 338
« Reply #3 on: April 19, 2012, 04:05:56 pm »
The back side of the tire rubs a little against the wheel well but only when I'm getting out of the drive way if I take a hard turn into a fishtale
Logged
Why build it if you can't drive it?
Pages: [1]   Go Up
« previous next »