« previous next »
Pages: [1]   Go Down

Author Topic: bolts size  (Read 5171 times)

Offline 1984gmchighserria

  • Newbie
  • Posts: 56
bolts size
« on: May 10, 2012, 09:12:56 am »
Does any one know the. 2 bolt sizes of the 1985 700r4 np208 bolt to the crossmember?
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: bolts size
« Reply #1 on: May 10, 2012, 07:24:45 pm »
     Does it have welded in nuts on the cross member ?
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline 1984gmchighserria

  • Newbie
  • Posts: 56
Re: bolts size
« Reply #2 on: May 10, 2012, 07:51:34 pm »
No, should it.
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: bolts size
« Reply #3 on: May 12, 2012, 12:40:37 pm »
     If it does not, just use 3/8" or 7/16" if it will fit with some nylock nuts so they wont back off.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline 1984gmchighserria

  • Newbie
  • Posts: 56
Re: bolts size
« Reply #4 on: May 13, 2012, 02:15:01 am »
Its the bolts that bolt the cross-member to the transmission.
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: bolts size
« Reply #5 on: May 13, 2012, 12:45:07 pm »
     Ah, I am out of town with the wife, but if nobody has answered by tomorrow when I get to work, I will pull my 208 off the shelf and get you the bolt size and thread pitch.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: bolts size
« Reply #6 on: May 14, 2012, 12:02:53 pm »
     So I checked my 208 on the shelf when I got into work, seems that I do not have the bolts for the crossmember, someone else is going to have to chime in with the size.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline 1984gmchighserria

  • Newbie
  • Posts: 56
Re: bolts size
« Reply #7 on: May 14, 2012, 12:05:16 pm »
Thanks aways blake74
Logged
Pages: [1]   Go Up
« previous next »