« previous next »
Pages: [1]   Go Down

Author Topic: tie rod ends  (Read 2609 times)

Offline Dan75k20

  • Frequent Member
  • **
  • Posts: 269
  • Newbie
tie rod ends
« on: April 11, 2014, 11:32:56 am »
Has any one adapted 10 bolt tie rods to a Dana 44 ? 75 chevy k 20
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: tie rod ends
« Reply #1 on: April 11, 2014, 06:59:51 pm »
     That is a good question, I thought they were the same.  Will have to wait till someone who knows for sure chimes in.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline Dan75k20

  • Frequent Member
  • **
  • Posts: 269
  • Newbie
Re: tie rod ends
« Reply #2 on: April 11, 2014, 09:35:38 pm »
I was just thinking maby this will work as long as the tie rod ends will fit the Dana knuckles the long ds tie rod is expensive and i can get the tube that the 10 bolt tie rods screw into and two new tie rods cheaper
Logged
Pages: [1]   Go Up
« previous next »