« previous next »
Pages: [1]   Go Down

Author Topic: Cab sheet metal piece question.  (Read 2896 times)

Offline mizozuman2

  • Newbie
  • Posts: 72
  • Something goes here... but what?
Cab sheet metal piece question.
« on: May 21, 2014, 08:08:15 am »
Hi,

 I just did a bit of searching, and couldn't come up with anything. It's the that the Bench seat mounts to, and is just above the Gas tank.

Does anyone make that piece of metal, or does it have to be custom fabbed?

http://imganuncios.mitula.net/custom_panel_trim_for_81_87_c10_k5_100201227283224424.jpg

It's literally right under the bench seat.

(Sorry if there's a technical term for it, but I've got no clue what the name is.)
Logged
1986 Chevrolet C10 "Heavy Half"
350 4bbl
Long bed/Reg Cab

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Cab sheet metal piece question.
« Reply #1 on: May 21, 2014, 08:11:26 am »
     E-mail the store here using the link above and Capt. will tell you if he has it or knows where to get it.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline sphinx

  • Registered Users
  • *
  • Posts: 124
Re: Cab sheet metal piece question.
« Reply #2 on: May 21, 2014, 07:02:24 pm »
Are you talking about the raised section under the seat?  I have seen the floor pan but not the under seat hump sections.  Let the Capt. know like bake74 said.  I seen YouTube videos where people have fabled up sections that were damaged.
Logged

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18462
    • http://www.73-87chevytrucks.com
Re: Cab sheet metal piece question.
« Reply #3 on: May 25, 2014, 12:50:11 pm »
The part directly under the seat is not offered.
Logged
Pages: [1]   Go Up
« previous next »