« previous next »
Pages: [1]   Go Down

Author Topic: Steering column question  (Read 4002 times)

Offline Kren420

  • Newbie
  • Posts: 97
  • 1986 C10 Silverado
Steering column question
« on: May 26, 2014, 08:04:21 pm »
Got this steering column but the lower shaft part has gone up inside the column.  Can I pull this out or am I screwed?
Logged

Offline Kren420

  • Newbie
  • Posts: 97
  • 1986 C10 Silverado
Re: Steering column question
« Reply #1 on: May 26, 2014, 08:56:56 pm »
Got it!! I just kinda figured what's the worst that could happen? I took her to the shop, slapped the column in a bench vice and yanked with all my might! Had to put one foot on the wall and push, almost landed on my face when it popped! 
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Steering column question
« Reply #2 on: May 27, 2014, 10:29:05 am »
     Welcome to the site, glad you got it figured out and back out.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline Kren420

  • Newbie
  • Posts: 97
  • 1986 C10 Silverado
Re: Steering column question
« Reply #3 on: May 27, 2014, 01:17:28 pm »
Thank you for the welcome! Will post pics of my 1986 C10 Silverado with a proper introduction when I put her back together.
Logged
Pages: [1]   Go Up
« previous next »