« previous next »
Pages: [1]   Go Down

Author Topic: Easy Sill Plate Restore  (Read 2747 times)

Offline LTZ C20

  • Senior Member
  • ****
  • Posts: 3795
  • "I'm here for a good time" -George Strait
Easy Sill Plate Restore
« on: July 12, 2014, 01:14:38 am »
Hey guys, this was easy and an evening time waster. I took my sill plates off, since they wouldn't clean up easily and I didn't feel like scrubbing lol, I just painted them.

Quick wash, 2 coats primer, 3 coats paint, 3 coats clear. Look new again.

Old


New
Logged
LTZ Cheyenne C20

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Easy Sill Plate Restore
« Reply #1 on: July 12, 2014, 09:42:15 am »
     You went with the black, have to see how well they hold up.  Did you rattle can them or spray gun ?
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline LTZ C20

  • Senior Member
  • ****
  • Posts: 3795
  • "I'm here for a good time" -George Strait
Re: Easy Sill Plate Restore
« Reply #2 on: July 12, 2014, 11:10:17 am »
Yea. I should hope pretty good. One day the new carpet kit will be black anyway. Should look better. I never actually step on them, they just kinda are there. I try to go over them straight to the mat. And my girlfriend always climbs over the seat and sits in the middle so she never hits them either.

Just rattle can. I had the priner, paint, and clear all on hand. I have a small paint selection in my garage for this reason. I've done a lot with rattle can and I'm pretty good.
« Last Edit: July 12, 2014, 11:13:28 am by LTZ C20 »
Logged
LTZ Cheyenne C20
Pages: [1]   Go Up
« previous next »