Carb to TBI conversion

[Irish_Alley]

https://sites.google.com/site/k5blazertbi/

does this help?

the other hole might not work out but you could just run a bolt that has a nut on one side of the bracket and another on the other side so it locks it in place. but tell you the truth i think you wont have to do this one you fix that angle

[Irish_Alley]

but what cable did you go with?

[fitz]

The spacer I was talking about would go between the 2 halfes of the universal bracket that you bought. You mentioned the bracket flexing, that sounds like part of the problem.
  Any chance of getting a stock GM TBI bracket at the junkyard and making it work?

[fitz]

The spacer I was talking about would go between the 2 halfes of the universal bracket that you bought.
  Any chance of getting a stock GM TBI bracket at the junkyard and making it work?

[LTZ C20]

The cable is the stock, original throttle cable.

Fitz, I might have a confused you a bit. The bracket doesn't flex when I step on the gas pedal,  the loop flexes. The bracket is solid as a rock. The loop flexes forward and back, not alot but a little with the forward and back motion of the pedal.

[Captkaos]

The cable doesn't have to be tight as it only controls the opening of the throttle. 

Chris Lucas
73-87chevytrucks.com
squarebody.biz

[LTZ C20]

Oh ok Capt. I thought that if it was tight then the slack would be all out and it b would work better.

[LTZ C20]

Gonna be doing an oil change, rotate tires and fix a leak so I'll try finding something to make a spacer and/or rearranging the cable and see how well I can get it to work better. I'll let ya guys know how it goes.

[Captkaos]

But it worked fine at one point right?