« previous next »
Pages: [1]   Go Down

Author Topic: Aftermarket doors  (Read 3371 times)

Offline Ds2014

  • Newbie
  • Posts: 74
  • Newbie
Aftermarket doors
« on: October 11, 2014, 11:52:46 am »
   Hello all I have an 81 stepside short bed. I purchased two doors from brothers trucks,and I am having trouble gettin them to line up. Did I waste money or is there a trick?
Logged

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Aftermarket doors
« Reply #1 on: October 12, 2014, 06:58:51 am »
Welcome to the site.
The body lines, sheet metal wasn't stellar as far as lining up, aftermarket panels are worse no matter how good the quality is. If the cab is rusty, or has had less than quality body work / rust repair it could be causing you problems as well.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline Ds2014

  • Newbie
  • Posts: 74
  • Newbie
Re: Aftermarket doors
« Reply #2 on: October 12, 2014, 07:47:48 am »
It's the fender side not lining up. I'm thinking of patch panel??
Logged

Offline fitz

  • Senior Member
  • ****
  • Posts: 2085
Re: Aftermarket doors
« Reply #3 on: October 12, 2014, 05:17:30 pm »
How good did the old ones line up?
Logged

Offline Ds2014

  • Newbie
  • Posts: 74
  • Newbie
Re: Aftermarket doors
« Reply #4 on: October 12, 2014, 05:52:17 pm »
It was in the scallop I'm going to call it, didn't line up at all way out! I patched the bottom of the passenger door today worked out good except the metal warped bad
Logged

Offline Ds2014

  • Newbie
  • Posts: 74
  • Newbie
Re: Aftermarket doors
« Reply #5 on: October 12, 2014, 05:53:58 pm »
But after bondo
Logged
Pages: [1]   Go Up
« previous next »