« previous next »
Pages: 1 [2]   Go Down

Author Topic: removing 4" lift and going to stock height?? '83 k10  (Read 14170 times)

Offline BBM3

  • Frequent Member
  • **
  • Posts: 326
Re: removing 4" lift and going to stock height?? '83 k10
« Reply #15 on: June 11, 2015, 06:27:14 pm »
Quote from: Irish_Alley on June 11, 2015, 06:13:57 pm
as long as its not binding you will be ok. i run 6" on a sm465 so my angle is greater than that and i been running that for years. not to mention everyone else with a stick shift. i mean if you want to go back to stock then have at it. i just dont want you to think something is wrong with a setup

It's all good.
Just pointing out that I think the OP may have been referring to U-joints rather than ball joints.
Logged

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: removing 4" lift and going to stock height?? '83 k10
« Reply #16 on: June 11, 2015, 07:51:09 pm »
no i understand didnt mean that for you but the op
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline 87project

  • Newbie
  • Posts: 14
  • Newbie
Re: removing 4" lift and going to stock height?? '83 k10
« Reply #17 on: June 11, 2015, 11:12:13 pm »
I have two stock front springs u can have... where are you?
Logged
Pages: 1 [2]   Go Up
« previous next »