« previous next »
Pages: [1]   Go Down

Author Topic: Drive shaft too short?  (Read 2076 times)

Offline 74-Blazin

  • New Users
  • Posts: 1
  • Newbie
Drive shaft too short?
« on: July 29, 2015, 06:05:33 pm »
I have a 1974 K-5 Blazer and I installed a 4 inch suspension lift, and when I went to install my front drive shaft it was too short??  What to do?  Why does it not fit?  I don't understand?
Logged

Offline bowmank10

  • Newbie
  • Posts: 35
  • Newbie
Re: Drive shaft too short?
« Reply #1 on: July 29, 2015, 07:31:13 pm »
I have 4 inch tuff country lift in my truck and the front driveshaft barely reaches (at the end of splines)....what brand lift is it? Did you make sure your front shaft is completely extended? (they can "freeze up" after sitting for a while) Hope this helps.

Sent from my XT1254 using Tapatalk

Logged
Git R Dun.

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: Drive shaft too short?
« Reply #2 on: August 02, 2015, 09:42:58 am »
the front shaft can handle a 6" lift. you do have the truck sitting on the axles/springs right and not still jacked up by the frame? the springs will also settle but havnt had a problem before with 6" lift. shocks attached?
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes
Pages: [1]   Go Up
« previous next »