OK I am going to go crazy,
I pulled off my hood, both front fenders and both doors to replace the rockers, cab braces and floor pans.
(Yes I do know my stuff on fabrication) Now comes the fun part-- on reassembly I am running into some problems getting this thing lined up right.
No matter what I do I can not get the fenders to line up with the doors and the hood to line up with anything.
Distance on all gaps is good at approx 1/4 inch. its just in and out all over.
Is there some
Starting point I should know about.
Note: this truck was never lined up upon purchase.
It seems as though the fit and finish of these old trucks was just not good as it could be.
Does anyone have measurments or any ideas that would help?
I know its not a dang Mercedes or something but I think it should line up better than this.
Thank you in advance for any help provided.
Truck is a 76 chevy C-10 stepside shortbox
76 stepside 2wd
GMPP 350/350
basicly a big money pit, but a lot of fun.