« previous next »
Pages: [1]   Go Down

Author Topic: Stainless Steel Brake Lines?  (Read 6653 times)

Offline 76_Scottsdale

  • Registered Users
  • *
  • Posts: 204
  • I'd rather push my Chevy than drive a Ford
Stainless Steel Brake Lines?
« on: February 13, 2008, 12:01:13 am »
Anyone know where to get pre-bent stainless steel brakes lines for a 76 K20? I've looked at   but they only off them for 1/2T 2WDs. Thanks.
Logged
1976 Scottsdale K20
350 C.I.D.
700R4
NP205
2 1/2" Lift
305/70/R16 BFG MT
True Dual 3" Flowmaster 40 Series Exhaust

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18454
    • http://www.73-87chevytrucks.com
Re: Stainless Steel Brake Lines?
« Reply #1 on: February 13, 2008, 09:06:28 am »
Logged

Offline RSBAD454

  • Junior Member
  • ***
  • Posts: 533
Re: Stainless Steel Brake Lines?
« Reply #2 on: February 17, 2008, 12:40:02 am »
I bought the entire set from inline tube.
Logged
“If you're listening to a rock star in order to get your information on who to vote for, you're a bigger moron than they are.”
http://prosites-prs.homestead.com/
http://

Offline eventhorizon66

  • Senior Member
  • ****
  • Posts: 1909
Re: Stainless Steel Brake Lines?
« Reply #3 on: February 17, 2008, 05:30:01 pm »
I bought a complete set of stainless hard brake lines from Inline Tube.  They fit very well and required only very minor tweaking.  I was very pleased.
« Last Edit: February 18, 2008, 11:13:23 am by eventhorizon66 »
Logged
'85 C10 SWB 350 700R4 TKO600

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18454
    • http://www.73-87chevytrucks.com
Re: Stainless Steel Brake Lines?
« Reply #4 on: February 18, 2008, 09:54:36 am »
I get all my stuff from either of those 2 places (normally Inline) and hadn't had any issues with them.  I am using Classic tubes stuff on my Jimmy TPI conversion.
Logged

Offline 76_Scottsdale

  • Registered Users
  • *
  • Posts: 204
  • I'd rather push my Chevy than drive a Ford
Re: Stainless Steel Brake Lines?
« Reply #5 on: February 18, 2008, 01:50:45 pm »
Sounds good I'll proabably go with Inline thanks guys. I'm also going to buy a unbent roll and bend up some complete hard lines for my tranny and carb.
Logged
1976 Scottsdale K20
350 C.I.D.
700R4
NP205
2 1/2" Lift
305/70/R16 BFG MT
True Dual 3" Flowmaster 40 Series Exhaust
Pages: [1]   Go Up
« previous next »