Author Topic: Pressure switch?  (Read 2743 times)

Offline Fairlane514

  • Frequent Member
  • **
  • Posts: 493
  • Newbie
Pressure switch?
« on: April 23, 2012, 08:21:45 pm »
Just above the oil filter on the adaptor is a pressure switch with two male spade terminals. The plug that plugs into it is making contact with my newly installed shorty header.
Is this a low pressure warning light? Can I unplug and then loop it?

 Its on a 84 with a Goodwrench 350.

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Pressure switch?
« Reply #1 on: April 24, 2012, 07:37:11 pm »
     I am not positive, but is that your oil sending unit for the gauge inside the cab.
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6610
Re: Pressure switch?
« Reply #2 on: April 24, 2012, 07:49:50 pm »
If it has pink and blue wires connected it might be for the electric choke heater on the carb.

Edit:
Can you use an angled fitting to gain needed clearance, then use heat reflective loom around the wires, connector and switch?  Or, maybe, relocate the switch next to the distributor at the back of the intake manifold and reroute the wiring.
« Last Edit: April 24, 2012, 07:59:39 pm by bd »
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19192
Re: Pressure switch?
« Reply #3 on: April 24, 2012, 08:39:16 pm »
Two wire is the switch which in 84 was used for the choke circuit. To BD you listem mmmm

,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6610
Re: Pressure switch?
« Reply #4 on: April 25, 2012, 12:36:51 am »
LOL - Dang, Vile!  I never noticed the Family resemblance, before....   ;D

Much it explains!
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19192
Re: Pressure switch?
« Reply #5 on: April 25, 2012, 08:59:29 pm »
 :P
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10