« previous next »
Pages: [1]   Go Down

Author Topic: flip kit installed  (Read 4050 times)

Offline jaime

  • Newbie
  • Posts: 72
  • Newbie
flip kit installed
« on: August 01, 2014, 12:57:05 am »
So I just install flip kit but I took measurement and im a quarter inch of one side  one wheel is closer to edge of  of the rear bed fender how can I fix this with out  basically taking everything apart
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: flip kit installed
« Reply #1 on: August 01, 2014, 07:17:42 am »
     Please tell us how you measured, from what points to what points.  Then somebody can give you idea's.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline jaime

  • Newbie
  • Posts: 72
  • Newbie
Re: flip kit installed
« Reply #2 on: August 01, 2014, 11:22:46 pm »
I measured from the chassis to the back of drum 
Logged

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18471
    • http://www.73-87chevytrucks.com
Re: flip kit installed
« Reply #3 on: August 17, 2014, 02:06:50 pm »
There is no adjustment in the axle. If you want the bed to match you will need to move it...  but give that it is 1/4" can you be sure you measure from the same spot?  The flip kit didn't do this, so did you measure prior?
Logged

Offline jaime

  • Newbie
  • Posts: 72
  • Newbie
Re: flip kit installed
« Reply #4 on: August 22, 2014, 12:09:07 am »
No I didnt measure prior but when I bought t the truck one of the rear tires did have a spacer  which is a querter of an inch thick
Logged
Pages: [1]   Go Up
« previous next »