« previous next »
Pages: [1]   Go Down

Author Topic: 350 Rebuild  (Read 2997 times)

Offline eramirez198121

  • Newbie
  • Posts: 18
350 Rebuild
« on: January 04, 2009, 01:11:06 pm »
Hi guys, I am new to this forum. some of the topic I have read here seem informative. I recently rebuild a 350 and I am about to start it up, just that i was told by a buddy that I had to prime the engine first with oil before turning it on. The oil is in the engine but he said that i had to pump the oil pump using a drill. He was not specific on how to perform it so I rather take my chances with you guys and maybe get better information here.
Logged

Offline frogman68

  • Junior Member
  • ***
  • Posts: 773
Re: 350 Rebuild
« Reply #1 on: January 04, 2009, 01:15:20 pm »
Gut a old distributor stick the end down into the oil pump shaft and attach the top to a drill go clockwise with the drill till oil comes to the top.

I think they actually have a tool for it but that is a "home remedy"
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19192
Re: 350 Rebuild
« Reply #2 on: January 04, 2009, 03:33:11 pm »
http://toolsandmore.us/index.asp?PageAction=VIEWPROD&ProdID=245

or just make your own like suggested or use a pump connected to an oil passage.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline eramirez198121

  • Newbie
  • Posts: 18
Re: 350 Rebuild
« Reply #3 on: January 04, 2009, 03:48:57 pm »
thanks I will do that  :)
Logged
Pages: [1]   Go Up
« previous next »