« previous next »
Pages: [1]   Go Down

Author Topic: Has anyone ever have to open up the notch on their torque converter?  (Read 3175 times)

Offline 82gmc3/4ton

  • Newbie
  • Posts: 59
Has anyone ever have to open up the notch on their torque converter?
« on: May 30, 2009, 03:54:10 pm »
I've been having problems trying to set my new converter.  I measured the pump gear notch and the new converter is .055 smaller than the one I'm replacing. Has anyone else have this problem? If so how did you fix it? Thanks
Logged

Offline Russ130

  • Frequent Member
  • **
  • Posts: 263
Re: Has anyone ever have to open up the notch on their torque converter?
« Reply #1 on: May 30, 2009, 08:23:27 pm »
I was helping a friend put in a new converter once and we ran into this problem. Since the notch is wrong it would be hard to assume everything else was fine so we returned it and got a new one that fit fine.
Logged

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18461
    • http://www.73-87chevytrucks.com
Re: Has anyone ever have to open up the notch on their torque converter?
« Reply #2 on: May 30, 2009, 08:54:28 pm »
I would return it also, depth plays an important part in it too.
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19181
Re: Has anyone ever have to open up the notch on their torque converter?
« Reply #3 on: May 30, 2009, 09:51:38 pm »
If it doesn't engage replace it. You could file it down but if it's new why bother. The machinist was too busy eating an egg sandwich to care about tolerance.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline 82gmc3/4ton

  • Newbie
  • Posts: 59
Re: Has anyone ever have to open up the notch on their torque converter?
« Reply #4 on: May 31, 2009, 08:52:46 am »
I was afraid of that. You all make great points. Thanks.
Logged

Offline 82gmc3/4ton

  • Newbie
  • Posts: 59
Re: Has anyone ever have to open up the notch on their torque converter?
« Reply #5 on: May 31, 2009, 05:12:20 pm »
Screw it I just bought a new one.
Logged
Pages: [1]   Go Up
« previous next »