« previous next »
Pages: [1]   Go Down

Author Topic: dash harness  (Read 3811 times)

Offline 85stepside

  • Newbie
  • Posts: 7
dash harness
« on: February 16, 2010, 07:53:11 pm »
I have a 85 custom deluxe w/air. I can pick up a complete dash harness uncut out of a 85 gmc 3/4 that is fully loaded. My question is how hard would it be to swap the harness.  And is it worth it? The harness is free, just trading things i don't need. Any input would be great.
Logged

Offline mitch sonsteng

  • Newbie
  • Posts: 33
Re: dash harness
« Reply #1 on: February 16, 2010, 08:15:58 pm »
I just swapped one out of a 73 custom for a 74 custom, the 73 was fryed, it wasn't to hard just took my time and looked at schematics. I got my schematics off of this website were on and they were the best I could find.
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19211
Re: dash harness
« Reply #2 on: February 16, 2010, 09:08:59 pm »
Why do you want to change it?
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline 85stepside

  • Newbie
  • Posts: 7
Re: dash harness
« Reply #3 on: February 17, 2010, 06:52:04 pm »
Vilezambonie' I  would just like to have pw/pl/cruse and tilt wheel. Plus i have 4 Great Danes that like to ride . Mainly i just like the opps. The harnss thats in the truck is still good.
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19211
Re: dash harness
« Reply #4 on: February 17, 2010, 07:16:07 pm »
Keep in mind you'll have to make holes in your doors to run the jumper harness. It shouldn't take you more than 2 hours if you're mechanically inclined.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline 85stepside

  • Newbie
  • Posts: 7
Re: dash harness
« Reply #5 on: February 17, 2010, 07:52:04 pm »
Vilezambonie' Thanks for the info. I have a pair of doors that already have pw/pl in them that are not on the truck. So thats not a big deal And I plan on getting it painted in a few mounths anyway.  I have been a diesel fleet mechanic for 10 years Just never tried to swap a complete harness over.
Logged
Pages: [1]   Go Up
« previous next »