« previous next »
Pages: [1]   Go Down

Author Topic: C-20 pinion seal ,gasket replace?  (Read 2646 times)

Offline tigwelder

  • Newbie
  • Posts: 83
C-20 pinion seal ,gasket replace?
« on: October 12, 2010, 07:28:31 am »
i have a leak on pinion support gasket on 80 C-20. can i remove the yoke, replace the pinion seal and the support gasket without changing the pinion setting? it is the 14 bolt 10 1/2'' RING GEAR. where can i find the seal and gasket?
Logged

Offline fitz

  • Senior Member
  • ****
  • Posts: 2086
Re: C-20 pinion seal ,gasket replace?
« Reply #1 on: October 12, 2010, 10:47:32 pm »
You can get the seal at Napa.
I've done it before by counting the turns on the pinion nut as you remove it.
Replace the seal then turn the nut the same amount of times to install it.
« Last Edit: October 13, 2010, 11:18:20 pm by fitz »
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19191
Re: C-20 pinion seal ,gasket replace?
« Reply #2 on: October 12, 2010, 10:56:52 pm »
Mark the pinion nut and the pinion flange with a punch. Tighten the nut back to where the dots line up
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10
Pages: [1]   Go Up
« previous next »