« previous next »
Pages: [1]   Go Down

Author Topic: CLeaning up the rearend  (Read 2281 times)

Offline TxFiddler

  • Registered Users
  • *
  • Posts: 184
CLeaning up the rearend
« on: April 24, 2011, 09:51:13 pm »
Well I got the Eaton LSD installed by one of the techs where I work.  All he does is Chevy rearends.  Anyhow, before I put it back under, its time to do some cleanup and painting.
Logged
80 C10 2wd / 427 BigBlock / 700R4 / 3:42 Eaton Posi LSD / 770 cfm Holley Street Avenger / Doug's Headers / MSD ProBillet Distributor / Champion 3 row Radiator

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: CLeaning up the rearend
« Reply #1 on: April 24, 2011, 09:59:17 pm »
     What are you using for paint ?  I am going to post a thread tomorrow when I get to work about my front and rear axle I just did using por-15 products.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline TxFiddler

  • Registered Users
  • *
  • Posts: 184
Re: CLeaning up the rearend
« Reply #2 on: April 24, 2011, 10:01:20 pm »
Thanks Bake.  I thought of using the POR15 as well.  Are you satisfied with it?  How did you apply it?
Logged
80 C10 2wd / 427 BigBlock / 700R4 / 3:42 Eaton Posi LSD / 770 cfm Holley Street Avenger / Doug's Headers / MSD ProBillet Distributor / Champion 3 row Radiator

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19192
Re: CLeaning up the rearend
« Reply #3 on: April 24, 2011, 11:28:43 pm »
Just make sure it's really clean and the POR15 will last.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: CLeaning up the rearend
« Reply #4 on: April 25, 2011, 12:48:22 am »
     I am posting tomorrow, under this topic labeled " front and rear axle results with por-15" I will have before and after photo's and what I found to work and not work.  Look for it there.
« Last Edit: April 25, 2011, 12:50:53 am by bake74 »
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom
Pages: [1]   Go Up
« previous next »