« previous next »
Pages: [1]   Go Down

Author Topic: th350 to 700r4  (Read 5407 times)

Offline bigblock73

  • Junior Member
  • ***
  • Posts: 504
  • Yeller
th350 to 700r4
« on: September 28, 2001, 11:55:00 am »
Does anyone or has anyone done this swap?  I am going to put in an overdrive trans (haven't purchased it yet) in place of the th350 in my '73 2WD and was wondering if I need to purchase a crossmember from an overdrive equipped truck or can I just reposition mine and drill new holes in the frame?

Logged
Jeff

'73 swb 2wd

73-87.com

Offline bigblock73

  • Junior Member
  • ***
  • Posts: 504
  • Yeller
Re: th350 to 700r4
« Reply #1 on: September 28, 2001, 12:03:00 pm »
whoops, wrong section.  I can't figure out how to move it so I'll re-post it to the general section.

Logged
Jeff

'73 swb 2wd

73-87.com

Offline blazer1961

  • Newbie
  • Posts: 13
Re: th350 to 700r4
« Reply #2 on: February 03, 2003, 03:08:00 pm »
should bolt right in.

Logged

Offline abig84

  • Newbie
  • Posts: 15
swap
« Reply #3 on: May 06, 2003, 06:20:00 pm »
the 700r4 is a bit longer then the th350 so you may have driveshaft problems and if it was a 4x4 the adapter between the transfercase and trans would be different

Logged

Offline 73K20

  • Registered Users
  • *
  • Posts: 228
Re: swap
« Reply #4 on: May 07, 2003, 07:03:00 am »
The adapters are the same between the tranny and t-case.  Both the TH350 and the 700R4 have 27 spline output shafts so there is no problem there either.  I think that you should be able to get by in using your old driveshafts too.

1973 K20 - 350/350/205

Logged
Pages: [1]   Go Up
« previous next »