« previous next »
Pages: [1]   Go Down

Author Topic: Vent Window Rivets  (Read 8813 times)

Offline Harmon

  • Registered Users
  • *
  • Posts: 165
Vent Window Rivets
« on: October 29, 2011, 05:19:09 pm »
What kind of tool do you use to  put in new rivets on the vent window's where the window swings to open?
Logged

Offline PromiseKeeper

  • Frequent Member
  • **
  • Posts: 438
Re: Vent Window Rivets
« Reply #1 on: October 29, 2011, 08:01:54 pm »
I dont know if you can still buy them or not, but an old body man gave me some exploding rivets....you put them in, heat them, and BLAM! Sounds like a .22 pistol LOL   But they worked great! I guess they used to use them on grills etc back in the day.
Logged
1980 C-10 2WD short & wide. 305 auto.

Offline Jason S

  • Senior Member
  • ****
  • Posts: 1561
Re: Vent Window Rivets
« Reply #2 on: October 30, 2011, 01:03:24 pm »
I bought replacement rivets from GM.  I inserted the rivet into the hinge and then took the assembly to a bench vice and used a hammer and punch to open(widen) the hollow end rivet  and then staked flat. The head (flat side) of the rivet was against the vice.

Logged
1973 GMC K2500, Super Custom, Camper Special, 350, TH350, NP203, 4.10's
1974 Chevrolet K10, Custom Deluxe, 350, SM465, NP203, 3.73's

"1) Peace through strength; 2) Trust but verify; 3) Beware of evil in the modern world"

Offline 79GMCChris

  • Newbie
  • Posts: 14
  • Newbie
Re: Vent Window Rivets
« Reply #3 on: November 03, 2011, 11:04:17 pm »
Harmon,

A few weeks ago I came across this article in a magazine about restoring the wing window and it addresses the wing window.
http://www.customclassictrucks.com/techarticles/1110cct_window_glass_rubber_install/viewall.html#ixzz1b6FkGWIF

It's a fairly recent article (October 2011 I think).  Hope this helps.
« Last Edit: November 03, 2011, 11:34:20 pm by Captkaos »
Logged
Chris
1979 GMC High Sierra 3/4ton 4X4

Offline Harmon

  • Registered Users
  • *
  • Posts: 165
Re: Vent Window Rivets
« Reply #4 on: November 06, 2011, 08:35:32 am »
Thanks for the information guys...these vent windows have been frustrating...I got the drivers side done with no problem.  The passenger side I took apart to clean and paint the vent window as it was well rusted....The drivers side I did nothing too...

Thanks for the help again.
Logged
Pages: [1]   Go Up
« previous next »