« previous next »
Pages: [1]   Go Down

Author Topic: 700R4 speedometer adaptor seal  (Read 3077 times)

Offline Fairlane514

  • Frequent Member
  • **
  • Posts: 493
  • Newbie
700R4 speedometer adaptor seal
« on: July 23, 2012, 08:06:45 pm »
Anyone have any luck with part numbers for the "O" ring and the small seal?

I have NAPA, Oreilly, Advance auto and Auto Zone near me. 
Logged

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6627
Re: 700R4 speedometer adaptor seal
« Reply #1 on: July 23, 2012, 08:43:30 pm »
Speedo sleeve O/R, GM/AC Delco P/N-15552872
Speedo driven gear seal, GM/AC Delco P/N-1361618

Be sure to check the driven gear and sleeve for wear; that's usually what causes them to leak.
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline Fairlane514

  • Frequent Member
  • **
  • Posts: 493
  • Newbie
Re: 700R4 speedometer adaptor seal
« Reply #2 on: July 23, 2012, 09:30:27 pm »
Thanks for the numbers, hopefully I will have it pulled tomorrow and I will know which drive gear I need.

Is the sleeve a replaceable part, or do I need to get the whole adaptor assembly?
Logged

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6627
Re: 700R4 speedometer adaptor seal
« Reply #3 on: July 23, 2012, 10:01:32 pm »
The sleeve (driven gear support) is serviceable.  There are two P/Ns with different offsets, depending on the number of teeth on (diameter of) the driven gear.
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)
Pages: [1]   Go Up
« previous next »