« previous next »
Pages: [1]   Go Down

Author Topic: What do you use to clean parts before paint?  (Read 2922 times)

Offline Harmon

  • Registered Users
  • *
  • Posts: 165
What do you use to clean parts before paint?
« on: November 23, 2012, 02:10:05 pm »
I took my intake and valve covers off.  I sandblasted them and they are ready for paint.  I have the intake bolts and other various brackets also ready.  My question is what degreaser do you use to prep for paint..and what kind of rag?
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19186
Re: What do you use to clean parts before paint?
« Reply #1 on: November 24, 2012, 11:51:37 am »
If you have already sandblasted I'd say blow them off with compressed air. Wax and grease remover is fine to use -prime and paint.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: What do you use to clean parts before paint?
« Reply #2 on: November 24, 2012, 06:30:55 pm »
Blow them off as Vile said. No need to use any degreaser or prep solvent if they are sandblasted clean metal. Prime with a self etching primer, and paint with a high quality engine paint.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs
Pages: [1]   Go Up
« previous next »