« previous next »
Pages: [1]   Go Down

Author Topic: Dana 44 front driveshaft yoke  (Read 7913 times)

Offline 81_Chevy

  • Frequent Member
  • **
  • Posts: 449
  • A Truck Is Built, Not Bought
Dana 44 front driveshaft yoke
« on: January 08, 2013, 02:54:31 pm »
my front drive shaft yoke is worn out really bad and then putting the lift kit in didn't help matters, just made them worse. where is a good place to get a new yoke? my drive shaft right now clicks and rattles like crazy when im driving with the front end engaged.
Logged
81 Chevy K20 350 4" Rough Country lift ridin on 35's ; 2 12 inch Subwoofers w/ a custom interior

Eagle Scout - 2012 Proud to be one!

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Dana 44 front driveshaft yoke
« Reply #1 on: January 09, 2013, 07:07:09 am »
The yoke on the axle is worn? I would think it is available new from GM, any driveshaft builder in your area, or Randy's Ring, and Pinion.
Not sure how that yoke would make the drive shaft click and rattle though. Sounds to me like your shaft needs to be rebuilt. Any drive shaft builder can do that for a couple hundred bucks. Had mine done in Yellow Snow for I think it was $213.00 parts, and labor. Rebuilt the cardan joint, and installed a new splined end, balanced it, and a slip yoke, with new joint.
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Dana 44 front driveshaft yoke
« Reply #2 on: January 09, 2013, 07:46:13 am »
Quote from: Blazin on January 09, 2013, 07:07:09 am
Sounds to me like your shaft needs to be rebuilt.

     I agree with Blazin, and this will be the best in the long run.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: Dana 44 front driveshaft yoke
« Reply #3 on: January 09, 2013, 10:35:54 am »
got one from the junk yard that was a couple inches longer than my stock one. the yard one was still tight in the splines,  rebuilt the cardan joint. years later its still good with no problems
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline pholliday1

  • Junior Member
  • ***
  • Posts: 632
  • 1990 V3500 Crew Cab
Re: Dana 44 front driveshaft yoke
« Reply #4 on: January 09, 2013, 01:13:55 pm »
Splines! be wary of worn splines they actually can "jump" if worn enough and putting the lift in and "stretching" the shaft a little will make it worse.Actually had the splines wear out on my last front driveshaft and my initial thought was the noise was coming from the transfercase.
Logged
VETERAN AND LIFETIME NRA MEMBER. WHAT DO YOU STAND FOR?
1991 V3500 CREWCAB SRW 454TBI GMC
1991 v3500 crewcab SRW 454tbi 480le 6" lift
1990 V3500 crewcab Dana 60 FF 14b 5:38 ratio 40 inch 11" lift
1989 v3500 crewcab 454TBI 5" lift

Offline 81_Chevy

  • Frequent Member
  • **
  • Posts: 449
  • A Truck Is Built, Not Bought
Re: Dana 44 front driveshaft yoke
« Reply #5 on: January 09, 2013, 01:30:24 pm »
Quote from: pholliday1 on January 09, 2013, 01:13:55 pm
Splines! be wary of worn splines they actually can "jump" if worn enough and putting the lift in and "stretching" the shaft a little will make it worse.Actually had the splines wear out on my last front driveshaft and my initial thought was the noise was coming from the transfercase.

i think that is what it is
Logged
81 Chevy K20 350 4" Rough Country lift ridin on 35's ; 2 12 inch Subwoofers w/ a custom interior

Eagle Scout - 2012 Proud to be one!

Offline westsidek20

  • Registered Users
  • *
  • Posts: 130
Re: Dana 44 front driveshaft yoke
« Reply #6 on: January 09, 2013, 06:32:21 pm »
dang pholiday, you hit everything on the head!  :D
Logged

Offline Blazin

  • Blazin new trails!
  • Senior Member
  • ****
  • Posts: 6130
Re: Dana 44 front driveshaft yoke
« Reply #7 on: January 09, 2013, 10:45:07 pm »
Didn't realize I missed the head! lol
Logged
Some people are like Slinkies. Not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs

Offline pholliday1

  • Junior Member
  • ***
  • Posts: 632
  • 1990 V3500 Crew Cab
Re: Dana 44 front driveshaft yoke
« Reply #8 on: January 10, 2013, 08:02:32 am »
LOL, not really just alot of past broken misery in my life.
Logged
VETERAN AND LIFETIME NRA MEMBER. WHAT DO YOU STAND FOR?
1991 V3500 CREWCAB SRW 454TBI GMC
1991 v3500 crewcab SRW 454tbi 480le 6" lift
1990 V3500 crewcab Dana 60 FF 14b 5:38 ratio 40 inch 11" lift
1989 v3500 crewcab 454TBI 5" lift

Offline westsidek20

  • Registered Users
  • *
  • Posts: 130
Re: Dana 44 front driveshaft yoke
« Reply #9 on: January 10, 2013, 09:11:11 am »
No disrespect Blazin, you always give great advise and helpful info.
It's just that Pholliday seems more of a newbie to the site and have read several post from him with very helpful info and his experience , a good member on the forum.

 8)
Logged
Pages: [1]   Go Up
« previous next »