Author Topic: 6.2 intake manifold options??  (Read 3936 times)

Offline Dirty Offio

  • Newbie
  • Posts: 17
  • Newbie
6.2 intake manifold options??
« on: August 16, 2013, 06:19:11 PM »
Hey all,

I just read a post and someone mentioned changing out the restrictive intake for something that flows better.  They mentioned the J code intake, but are there any other manifolds that will work?  The block design looks like a BOP block, (Oldsmobile if I had to guess.) I know the engine was designed by Detroit, but is there any chance of an Olds or ?? manifold fitting?

Thanks!

Offio

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18403
    • http://www.73-87chevytrucks.com
Re: 6.2 intake manifold options??
« Reply #1 on: September 26, 2013, 12:13:41 AM »
No chance...

Offline Edahall

  • Frequent Member
  • **
  • Posts: 311
Re: 6.2 intake manifold options??
« Reply #2 on: September 26, 2013, 11:15:01 PM »
Well, if you're looking to save money, you could chip out the pedestal.  Once that's done, you can plug up the hole with a cap and epoxy.  You'll end up with the poor mans J code intake manifold
1990 ¾ ton 4x4 Chevy Suburban
-Cummins Diesel - 12 valve - factory rebuilt
-6 speed bullet proof manual transmission - NV5600
-Gear Vendors Overdrive
-Upgraded Holset HX-35 turbo
-NP205 iron transfer case
-3.73 gears
-2" Lift

Offline Dirty Offio

  • Newbie
  • Posts: 17
  • Newbie
Re: 6.2 intake manifold options??
« Reply #3 on: December 17, 2013, 11:06:38 AM »
Figures!  lol.  Oh well, I will see if I can find a J code manifold!

Cheers!