03 and up crown vic crossmember swap

[dale]

In the process of doing this now   Anybody else done this on a square body chevy?  Not too much work, and cheap!! 12" rototrs, dual piston calipers and ifs!

[454Man]

Haven't done it but sounds kinda cool. Where did you here about this

What's under the hood??? If you have to ask maybe we shouldn't race...

[dale]

Haven't done it but sounds kinda cool. Where did you here about this

What's under the hood??? If you have to ask maybe we shouldn't race...

read about it online... theres one done on a 67 f100,  y not put it on a c10!
I had to narrow it 5" to fit the Chevy frame.. I got it off a 2010 crown Vic hwy patrol car.  375 complete.... they pulled it off!  Now you could buy an aftermarket for 1500-3000 but why?

[HAULIN IT]

Hmmm  

[Irish_Alley]

didnt gas monkey just do this?

[blazing816]

didnt gas monkey just do this?

Yeah but it was a Dodge truck (ford front end and chevy engine).

[Johnny walnuts]

gas monkey also did it on a 68 Ford f100, Frankenstein Ford.   which turned out pretty bad ass

[dale]

Hmmm

What you thinking?  Bad idea

[Captkaos]

I don't see the point, the factory rotors are 11.88" what is the extra .12" going to get you?  And if you want bigger, why not go aftermarket with 13's and multi piston?

[dale]

I don't see the point, the factory rotors are 11.88" what is the extra .12" going to get you?  And if you want bigger, why not go aftermarket with 13's and multi piston?

couple thousand dollars vs 375, rotors are 12" and it does have dual pistons calipers,  also strut coil overs with rack...o, and its aluminum, not to mention its a 5" drop just bolting it on!! All you do is narrow it 5" and put a 94 mustang rack  ($52 dollars @ autozone) on it and your good to go!!

[HAULIN IT]

Any photos of the progress?

[dale]

Any photos of the progress?

coming soon

[dale]

Heres one..  have better ones soon

[dale]

Working on bigger ones

[dale]

Dropped truck 4"s. Will go lower when I put drive train and frontend back together