« previous next »
Pages: [1]   Go Down

Author Topic: starter wire goes nowhere  (Read 2884 times)

Offline 75_chevy

  • Registered Users
  • *
  • Posts: 181
  • Newbie
starter wire goes nowhere
« on: March 12, 2014, 11:18:06 pm »

my truck starts and runs.. what is this connector used for?


Sent from my iPhone using Tapatalk
Logged

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: starter wire goes nowhere
« Reply #1 on: March 12, 2014, 11:47:01 pm »
dont worry about it. but its labeled "R" for ignition and it give a coil a full 12v while cranking. with points style ignition there is a resistor limiting the amount of volts to the coil. the "R" post will bypass the resistor and give the coil a full 12v at start up for a easier start up. this is for the old points style ignition
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline 75_chevy

  • Registered Users
  • *
  • Posts: 181
  • Newbie
Re: starter wire goes nowhere
« Reply #2 on: March 13, 2014, 12:51:59 am »
ahh thanks again irish!! :)


Sent from my iPhone using Tapatalk
Logged

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: starter wire goes nowhere
« Reply #3 on: March 13, 2014, 08:41:24 am »
     So I am assuming that in the 3rd pic, where you have the red and black circle on, the yellow sheathed wire is actually the "s" wire that actually energizes your starter.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom
Pages: [1]   Go Up
« previous next »