« previous next »
Pages: [1]   Go Down

Author Topic: Vent Window  (Read 2457 times)

Offline michael.francis.5876

  • Newbie
  • Posts: 14
  • Newbie
Vent Window
« on: January 18, 2015, 04:33:46 pm »
1976 Chevy K10. I replaced the leaky vent window on the drivers side. For some reason the bottom of the window has a gap in it that let's air in. I took it back out to make sure the where were in right and that the window was all the way down. I have the washers in correctly as I have the flat one facing forward with a washer on top of the window frame followed by the other 2 washers spring, nut lock and lock. Anyone else experience this?
Logged

Offline Jason S

  • Senior Member
  • ****
  • Posts: 1561
Re: Vent Window
« Reply #1 on: January 18, 2015, 07:33:13 pm »
Could you post a photo?
Logged
1973 GMC K2500, Super Custom, Camper Special, 350, TH350, NP203, 4.10's
1974 Chevrolet K10, Custom Deluxe, 350, SM465, NP203, 3.73's

"1) Peace through strength; 2) Trust but verify; 3) Beware of evil in the modern world"

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19186
Re: Vent Window
« Reply #2 on: January 18, 2015, 07:34:35 pm »
Did you use the correct year vent window?
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline michael.francis.5876

  • Newbie
  • Posts: 14
  • Newbie
Re: Vent Window
« Reply #3 on: January 18, 2015, 09:06:19 pm »
I'll try and get a pic tomorrow. I never replaced the window, just the seal. It is the exact same seal as I took off.
Logged
Pages: [1]   Go Up
« previous next »