Roll on bed liner Herculiner

[2butterbeans]

Have any you guys tried Herculiner? What did you think of it?

[roundhouse]

Works ok

I wouldn't use it on a truckbed
It's too cheap to get one sprayed in

I used it inside my 73 Bronco
Since all the truckbed places will spray a 8 foot bed for $99 but wanted $350 to do the inside in my bronco witch is waay smaller than a truckbed


Sent from my iPhone using Tapatalk

[kalbert]

I've used it on small things. Stair treads, trailer tongues, floor board on a forklift, inside a small fishing boat, stuff like that. I wouldn't use it on a whole bed. Too hard to make an even coat over a large area. The amount you'd need to make a coating half as thick as a spray on would cost almost the same, and it'd be blotchy and uneven. Worked very well on the little stuff though. Non slip and with good prep held up well and did not peel. Same goes for other DIY bed coatings.

[roundhouse]

Makes the best glue in the world
They should make it without the clumps and in a squeeze tube


Sent from my iPhone using Tapatalk

[Blazin]

Its sucks!