« previous next »
Pages: [1]   Go Down

Author Topic: Distributor not firing  (Read 2742 times)

Offline bigge31566

  • Newbie
  • Posts: 24
  • Newbie
Distributor not firing
« on: December 21, 2015, 03:59:34 pm »
I have been trying to start my truck with Chevy 350 with a Accel HEI dist but Im not getting fire to plugs, I checked power to dist at little over 12 ams, but when trying to  crank it drops to between 8 and 9 volts, is this enough to still fire off,
Logged

Offline Rattler12

  • Registered Users
  • *
  • Posts: 219
  • Old Geezer
Re: Distributor not firing
« Reply #1 on: December 23, 2015, 09:36:37 am »
If its dropping that low do a battery check and put a load directly on the battery with terminals removed. If the battery tests @ 12.5 V while not under load and drops to 8 under load sounds like a bad battery. Is the starter turning at regular speed? 
Logged
83 C-10 shorty 454, 5spd, 3:73 posi

Offline Captain Swampy

  • Junior Member
  • ***
  • Posts: 504
  • Wisconsin
Re: Distributor not firing
« Reply #2 on: December 25, 2015, 09:15:33 pm »
Your battery sounds weak, but the ignition should still fire. You might have a bad ignition module or coil. Is the power wire hooked up to the correct terminal on the distributor?
Logged
1987  350TBI 700R4  4X4  4.56 gears  33" BFG All Terrain


http://forum.73-87chevytrucks.com/smforum/index.php?topic=32209.0

Offline edgarollins

  • Newbie
  • Posts: 6
  • Eddy
Re: Distributor not firing
« Reply #3 on: December 27, 2015, 07:02:18 pm »
In agreement with Rattler, it could be an indication of a bad battery.  Some HEI distributors won't fire on anything less than 10v, or at least that was the case with the original equipment from Chevy.  Have the battery tested at a local auto store.  Most do it for free and you will know for sure.
Logged
Pages: [1]   Go Up
« previous next »