Noise from crankshaft pulley?

[Rough75C20]

Hello all,

Discovered a rattling noise coming from my crankshaft pulley. I noticed this morning almost like a rattling noise coming from the belts. further investigation showed noise coming from the crankshaft pulley area. Cant identify the cause because the belts seem to be in good condition and the correct tightness. Any ideas? I couldn't figure out how to post the video here so there is a link to my tiktok page showing the video. Engine is a 1982 305.



Thank you

[Rough75C20]

https://www.tiktok.com/t/ZTkGYgH2u/


Sent from my iPhone using Tapatalk

[bd]

It looks like the elastomer ring is walking out from between the balancer outer ring and its hub.  The outer ring is probably slipping, so you will need to replace the balancer assembly and seal.  A still picture should make it more discernible.  Don't wait too long, or the ring might begin to rub and drag against the timing chain cover.  Good weekend project.

[Rough75C20]

Hello Bd,

Thank you I will try to get some pictures later today.

Thank you


Sent from my iPhone using Tapatalk

[Rough75C20]

Well I think you were right about the balancer I believe the noise was the rubbing on timing chain cover. I believe it’s the 6.75 inch diameter balancer. Do I need a new pulley as well? Also, where to get a new seal?

Thank you


Sent from my iPhone using Tapatalk

[bd]

Be sure to pick up a dampener for your specific year, model vehicle, and engine so that the timing marks are correct (assuming the engine is original).  The dampener and timing marks need to match.  Replace the front crank seal too (it may or may not come with the new dampener).  That pulley looks like someone beat on it with a large hammer.  The resulting dimples have narrowed the groove, squeezing the belt.  If you can find a proper replacement pulley, it would be prudent for the sake of belt life.  In the meantime, don't drive it.

[Rough75C20]

Thanks bd, I will be replacing everything.

Thank you


Sent from my iPhone using Tapatalk

[Rough75C20]

Why does my truck seem to have a different style crank pulley? It seems to have a serpentine style belt in the front and two v style slots is this normal?

Thank you


Sent from my iPhone using Tapatalk

[bd]

That isn't normal for a 1975 vintage truck.  Serpentine belts came on ca 1985 (?) and later vehicles to drive the alternator and water pump.  The one imaged below may work, but is machined from aluminum making it pricey: https://www.summitracing.com/parts/mch-4021-08/make/chevrolet.  In addition, a reviewer said it is smaller than the OEM pulley, although the manufacturer claims otherwise.  With a little leg work and Internet searches you might find other brands that are steel and less expensive.