Rockers

[JJSZABO]

Hey Folks:

I am getting ready to install new rockers and cab corners this weekend.  Does anyone have any pictures of the process?

My project:

86 Chevy C-10 SWB, Fleetside

A few pictures




Thanks in advance.

Jeff

[VileZambonie]

I don't have any pix as it's a task I like to forget about...

I can give you a few tips though... Make sure you line everything up mint with the door and the bed before you weld anything.

[Captkaos]

Blazin has the pics of his I believe, I was going to DL them for a write-up, but I have been busy trying to get a Suburban running.

[JJSZABO]

Thanks for responding.  I think I'll go with what I have been reading and the "few" pictures that I found.  Does anyone know where i might find a new cab - in case something goes wrong.

I'll post pictures when I am done.

Jeff

[Captkaos]

Do a search for Blazin as the username.  He has all the pic on an image file, just not sure where...

[JJSZABO]

Thanks Chris

[Blazin]

Try this out.
http://s136.photobucket.com/albums/q165/BlazinK30/Chevy%20floor%20rocker%20cab%20corner%20replace/
Or this.
http://s136.photobucket.com/albums/q165/BlazinK30/Chevy%20truck%20rocker%20cab%20corner%20replace/
Let me know if you can se all the pics, or any of them for that matter!
 Der why didn't I think abut doing it this way before?
 If you look through the old posts I have typed out detailed instructions on this process a few times over the last few years.

[JJSZABO]

Thanks Blazin - You Rock!!  That is what I was looking for.  I went through all your old posts and printed everything you had said to do concerning Rockers, floors and cab corners.  Thanks for all your help.  I'll post pictures as I progress.

Jeff

[Captkaos]

Der why didn't I think abut doing it this way before?
 If you look through the old posts I have typed out detailed instructions on this process a few times over the last few years.

I was thinking that is what I would do to get the "steps" required along with your pictures.  Now I have both ideas in one post!

[Blazin]

Yes do them into an article for the tech page.