« previous next »
Pages: [1]   Go Down

Author Topic: signals  (Read 4148 times)

Offline the_legend_1981

  • Frequent Member
  • **
  • Posts: 288
signals
« on: May 03, 2008, 05:45:00 pm »
One of my brake lights was out so i changed the bulb... it worked fine.  On my way home i went to signal and it didn't blink.  This is only happening with my headlights on. what could the problem be?
Logged

Offline Bitzer!

  • Junior Member
  • ***
  • Posts: 906
  • Smiles per gallon
Re: signals
« Reply #1 on: May 03, 2008, 06:07:17 pm »

Did you change it with the same type of bulb?
Logged
1979 GMC CrewCab  C20 1t
454 750 Holley,TH350, 14bolt diff fully floating
Why aren't there 8 days in a week!
A K5 rolling shell *new addition*

Offline the_legend_1981

  • Frequent Member
  • **
  • Posts: 288
Re: signals
« Reply #2 on: May 03, 2008, 07:01:46 pm »
yeah
Logged

Offline Bitzer!

  • Junior Member
  • ***
  • Posts: 906
  • Smiles per gallon
Re: signals
« Reply #3 on: May 04, 2008, 01:03:05 am »
jus checking! thought I'd better start with the basics ;)
Logged
1979 GMC CrewCab  C20 1t
454 750 Holley,TH350, 14bolt diff fully floating
Why aren't there 8 days in a week!
A K5 rolling shell *new addition*

Offline DnStClr

  • Senior Member
  • ****
  • Posts: 1806
Re: signals
« Reply #4 on: May 04, 2008, 01:12:15 pm »
You should check the signal at the connector with a test light to see if there's 12v coming to the socket intermitently when the blinker is on. If the signal is there, it has to be a problem with the bulb, as Bitzer suggests. If no signal at the socket, there may be a problem with the grounding wire right there at the socket-to frame.
Logged
Don
87 Chevy Silverado

Offline arkoza63

  • Newbie
  • Posts: 37
Re: signals
« Reply #5 on: May 12, 2008, 11:54:58 am »
does it blink with the hazards on? if not your turn switch may be the problem.
Logged
gone crazy, be back soon
Pages: [1]   Go Up
« previous next »