« previous next »
Pages: [1]   Go Down

Author Topic: need help with steering wheel install!!  (Read 6476 times)

Offline gumby3419

  • Newbie
  • Posts: 5
need help with steering wheel install!!
« on: October 13, 2008, 03:24:33 pm »
After removing the steering wheel there is a lock plate underneath. To remove this lockplate there is a retaining ring/clip that sits in a groove on the shaft. Does anyone know where I can find this clip? I have searched everywhere and no one seems to even know what I'm talking about. If need be I can post some pictures. Any help would be greatly appreciated.
Logged
Old enough to know better, young enough not to care!

Offline gumby3419

  • Newbie
  • Posts: 5
Re: need help with steering wheel install!!
« Reply #1 on: October 13, 2008, 03:27:50 pm »
Sorry, it's for an 86 C-10.
Logged
Old enough to know better, young enough not to care!

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18454
    • http://www.73-87chevytrucks.com
Re: need help with steering wheel install!!
« Reply #2 on: October 13, 2008, 04:03:15 pm »
Logged

Offline ccz145a

  • Senior Member
  • ****
  • Posts: 1393
Re: need help with steering wheel install!!
« Reply #3 on: October 13, 2008, 04:09:01 pm »
Logged
1975 C10 Silverado LWB, 454CID, TH400, 10bolt 3.42
11MPG Downhill w/tailwind (but there ain't no hills here)

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19167
Re: need help with steering wheel install!!
« Reply #4 on: October 13, 2008, 06:45:19 pm »
What happened to yours? You can get it from GM. You use a lockplate depressor to expose the snap ring.

http://www.toolking.com/products/1080650.aspx?googlebase=W80650
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline gumby3419

  • Newbie
  • Posts: 5
Re: need help with steering wheel install!!
« Reply #5 on: October 14, 2008, 11:50:14 am »
Thanks for the pics...but I knew where it was located on the shaft. I needed to know where I can buy a new one. I screwed up taking it off and bent it out of shape.
Logged
Old enough to know better, young enough not to care!
Pages: [1]   Go Up
« previous next »