Adjusting Door Question

[Kris_77stepside]

So I'm probably going to sound like an idiot cause I went to auto body school but I can't seem to figure out how to slide the door back as in close the gab between the rear of the cab and back edge of the door.  I took the fender off and loosened the 3 bolts on the bottom hinge where it connects to the cab,  then the 2 on the top hinge.  But there is also another one on the top hinge where instead of a bolt head, there is a nut welded to the hinge and looks like a bolt going from the inside of the cab to the nut, but when I looked under the dash and everything there was no bolt head anywhere that would allow you to loosen it.  If anyone can help that would be awesome. 

[frogman68]

That top one is a bear

Look up by the parking brake pedal you will see a hole the bolt is in there

[Kris_77stepside]

Well I was working on the passenger side but do they have like caps or something over them cause the glove box is out and I was looking and feeling in there but there was no bolt heads.  I found a round spot kinda by the dash where it looks like it is but it was smooth.  I'll have to look better tomorrow.

[VileZambonie]

remove the grommet for the door jam switch wiring and it's a straight shot to the bolt.

[HAULIN IT]

Tape the socket on the extension if you don't have the kind that lock on 

[Kris_77stepside]

Just thought I would let everyone know I figured it out.  Turns out that flat part where the bolt when to was a plug/cap thing that was covering up the head.  Got the door adjusted so it shuts like new. 

[VileZambonie]

That plug thing is the grommet I mentioned above. Glad you got it adjusted. Make sure your hinge bushings are good and striker bushing is in tact.

[thirsty]

Tape the socket on the extension if you don't have the kind that lock on 

Good advise. I dropped the bolt down there once, took a while to get it out.

[VileZambonie]

Get some cheap magnetic extensions