« previous next »
Pages: [1]   Go Down

Author Topic: Oil Pump Shaft Retainer??  (Read 5383 times)

Offline 76 3+3

  • Newbie
  • Posts: 26
Oil Pump Shaft Retainer??
« on: March 12, 2009, 01:24:10 am »
Pulled oil pan off to replace rear main seal and Fel-pro provided an Oil Pump Shaft Retainer replacement. I can see this goes onto the oil pump shaft but I am not sure how to remove the old one. I am afraid I will break or damage the oil shaft. Any suggestions? This is on a Generation I Chevy 350 1975.
Logged

Offline HAULIN IT

  • Senior Member
  • ****
  • Posts: 1542
Re: Oil Pump Shaft Retainer??
« Reply #1 on: March 12, 2009, 08:00:38 am »
Is the old one metal or plastic? If it's metal...leave it alone, if it's plastic...it will likely be dry/brittle & break when you start to remove it. They just slide off, if it gives you trouble you could cut it lengthwise to release it. Lorne
Logged

Offline 76 3+3

  • Newbie
  • Posts: 26
Re: Oil Pump Shaft Retainer??
« Reply #2 on: March 12, 2009, 09:25:38 am »
Thanks for the info. I ended up pulling the shaft apart (shaft snaps together under plastic retainer) and then breaking the old plastic retainer off.
Logged

Online VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19180
Re: Oil Pump Shaft Retainer??
« Reply #3 on: March 12, 2009, 10:19:18 am »
I would replace it with a steel sleeve shaft. they're only $10-15 bucks.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline 76 3+3

  • Newbie
  • Posts: 26
Re: Oil Pump Shaft Retainer??
« Reply #4 on: March 13, 2009, 03:27:35 am »
I will keep the metal sleeve in mind next go around. I got the new plastic one on and rear seal/pan are back on. Thanks the info.
Logged
Pages: [1]   Go Up
« previous next »