« previous next »
Pages: [1]   Go Down

Author Topic: Rearend  (Read 2534 times)

Offline brlarl

  • Registered Users
  • *
  • Posts: 114
  • Big Bad Bowtie!!!
Rearend
« on: May 13, 2009, 12:00:08 pm »
Can anyone tell me what Chevy rear ends if any beyond 87 will fit in an 85 C10 1/2 ton as a direct bolt on?  Can you also tell me how to determine the gear ratios based on the housing markings?  THX
Logged
Don't wear a tux without the BOWTIE!!!

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19188
Re: Rearend
« Reply #1 on: May 13, 2009, 02:00:02 pm »
87-91 RV series are a direct fit. Axle ratio's aren't stamped on the housing.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline brlarl

  • Registered Users
  • *
  • Posts: 114
  • Big Bad Bowtie!!!
Re: Rearend
« Reply #2 on: May 13, 2009, 03:06:46 pm »
What would it take to install a newer year model rear end in the C10?
Logged
Don't wear a tux without the BOWTIE!!!

Offline HAULIN IT

  • Senior Member
  • ****
  • Posts: 1542
Re: Rearend
« Reply #3 on: May 13, 2009, 03:23:38 pm »
The spring perches/shock mounts are in different locations. The brake lines & E-brake cables are different & depending on the year/application...maybe the wheel bolt pattern. Do-able, but no where near a bolt-in deal. Lorne
« Last Edit: May 13, 2009, 03:25:59 pm by HAULIN IT »
Logged

Offline Blue 82

  • Frequent Member
  • **
  • Posts: 281
Re: Rearend
« Reply #4 on: May 13, 2009, 03:36:17 pm »
I have a 14 bolt rear out of a 454SS truck
it's about an inch narrower on each side vs the 8.5" 10 bolt from what i remember

I'll save it for another project.....

Logged
82 stepside 2wd 355/th350/3.08 posi
Pages: [1]   Go Up
« previous next »