« previous next »
Pages: [1]   Go Down

Author Topic: Which holes to use for heater core cooling lines?  (Read 5497 times)

Offline Mike Phillips

  • Junior Member
  • ***
  • Posts: 626
Which holes to use for heater core cooling lines?
« on: July 04, 2009, 05:33:01 pm »
Which holes to use for heater core cooling lines?

The angle between holes 5 and 1 is to sharp.




Would it be alright to connect 5 and 2?

3 will get a 90 degree fitting and go directly to the heater core.
4 will get a straight fitting and go to the heater core. 

Then put a plug in hole 1


 ???
« Last Edit: July 04, 2009, 05:36:25 pm by Mike Phillips »
Logged

Offline Russ130

  • Frequent Member
  • **
  • Posts: 263
Re: Which holes to use for heater core cooling lines?
« Reply #1 on: July 04, 2009, 11:08:49 pm »
Personally I'd plug 5, 2 and 1 then use 4 and 3 for the heater core.
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19169
Re: Which holes to use for heater core cooling lines?
« Reply #2 on: July 04, 2009, 11:20:16 pm »
1 and 5 are where they go. You should use the shorter brass fittings. Look at the one on mine...

Logged
,                           ___ 
                         /  _ _ _\_
              ⌠¯¯¯¯¯'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: Which holes to use for heater core cooling lines?
« Reply #3 on: July 04, 2009, 11:59:12 pm »
Quote from: VileZambonie on July 04, 2009, 11:20:16 pm
1 and 5 are where they go. You should use the shorter brass fittings. Look at the one on mine...


show off  ;)
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline Mike Phillips

  • Junior Member
  • ***
  • Posts: 626
Re: Which holes to use for heater core cooling lines?
« Reply #4 on: July 05, 2009, 01:00:33 am »
Thanks VileZambonie

I'll check with NAPA about getting some brass fittings.  The steel ones I was testing was all the local speed shop had and I was trying to get parts while I was running errands on Friday.

This project is starting to drain me...

:)
Logged

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18454
    • http://www.73-87chevytrucks.com
Re: Which holes to use for heater core cooling lines?
« Reply #5 on: July 06, 2009, 12:58:06 pm »
You should be able to get a molded hose for it, OR the hose off the donor.
I ran a short section of rubber hose on mine for a while.
Logged
Pages: [1]   Go Up
« previous next »