« previous next »
Pages: [1]   Go Down

Author Topic: 86 driveshaft  (Read 2960 times)

Offline mooseknuckles

  • Newbie
  • Posts: 21
86 driveshaft
« on: September 19, 2009, 07:31:30 am »
Ive lowered my 86 chevy with a flip kit in the rear, and it has the two piece driveshaft with the hanger bearing in the middle, and im noticing that the driveshaft angle from the tranny to the hanger bearing looks messed up. should I section the mount and weld it back up to correct the angle, or can I replace the hanger and shaft with a one piece driveshaft?
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19180
Re: 86 driveshaft
« Reply #1 on: September 19, 2009, 09:00:19 am »
One piece or make the short bracket. I have one I made.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline mooseknuckles

  • Newbie
  • Posts: 21
Re: 86 driveshaft
« Reply #2 on: September 21, 2009, 05:46:12 pm »
A buddy of mine told me he new a guy who used a 4" aluminum driveshaft  out of a '89 or '90 chevy. Have you heard of this? I guess it would work if I found one the same length.
Logged
Pages: [1]   Go Up
« previous next »