« previous next »
Pages: [1]   Go Down

Author Topic: Alignment shims looking odd  (Read 2997 times)

Offline GUITAR1989

  • Registered Users
  • *
  • Posts: 198
    • What I've done to my truck so far :)
Alignment shims looking odd
« on: January 08, 2011, 02:49:17 pm »
Hey guys check these out and tell me what you think...should it be even on both sides? also some are sticking out higher than others..could they pop out and cause major problems?

Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19168
Re: Alignment shims looking odd
« Reply #1 on: January 08, 2011, 02:51:18 pm »
No they should not be even. I always use new shims of the same size so it doesn't look like that but as long as they are torqued they are fine.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline GUITAR1989

  • Registered Users
  • *
  • Posts: 198
    • What I've done to my truck so far :)
Re: Alignment shims looking odd
« Reply #2 on: January 08, 2011, 03:08:22 pm »
ah right on i just thought they might be pushing out. So its ok that theres a different number of shims on the driver side than the passanger side?
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19168
Re: Alignment shims looking odd
« Reply #3 on: January 08, 2011, 03:11:27 pm »
Yes, this is how you set your camber and caster
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10
Pages: [1]   Go Up
« previous next »