« previous next »
Pages: 1 [2] 3   Go Down

Author Topic: why does my truck run the way it does?  (Read 12790 times)

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19192
Re: why does my truck run the way it does?
« Reply #15 on: April 18, 2012, 08:18:16 pm »
tune it up and set the timing.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline rusty but trusty

  • Newbie
  • Posts: 54
  • Newbie
Re: why does my truck run the way it does?
« Reply #16 on: April 19, 2012, 05:40:37 pm »
yes the service engine soon light comes on and how would i go about doing a tune up? yes this is a dumb question but i really don't know much. and thanks too all of you
Logged
87 GMC V1500 305 700R4 NP208 and 10 bolts front and rear

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19192
Re: why does my truck run the way it does?
« Reply #17 on: April 21, 2012, 11:50:34 am »
Replace the spark plugs, wires, cap, rotor, fuel filter, air filter PCV valve, set the timing, disconnect the negative battery cable for a minute to reset the adaptives.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline rusty but trusty

  • Newbie
  • Posts: 54
  • Newbie
Re: why does my truck run the way it does?
« Reply #18 on: April 23, 2012, 07:07:45 pm »
ok iv done oil change new cap and rotor and new wires new plugs new fuel and air filters but i cant find my pcv valve all of my breather lines on my valvecovers go to my intake manifold
Logged
87 GMC V1500 305 700R4 NP208 and 10 bolts front and rear

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6610
Re: why does my truck run the way it does?
« Reply #19 on: April 23, 2012, 07:31:52 pm »
The PCV valve should be at the end of a 3/8" vacuum line plugged into the top of a valve cover.  Since your engine has been replaced, it could be either side.
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: why does my truck run the way it does?
« Reply #20 on: April 24, 2012, 07:36:07 pm »
Quote from: bd on April 23, 2012, 07:31:52 pm
The PCV valve should be at the end of a 3/8" vacuum line plugged into the top of a valve cover.  Since your engine has been replaced, it could be either side.

     You might only see the top black part of the PCV valve, the silver part might be pushed into the rubber grommet.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline rusty but trusty

  • Newbie
  • Posts: 54
  • Newbie
Re: why does my truck run the way it does?
« Reply #21 on: April 25, 2012, 03:23:42 pm »
bake74 thank you so much i have looked and looked and then i read your post and i felt kinda dumb but enlightned
Logged
87 GMC V1500 305 700R4 NP208 and 10 bolts front and rear

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: why does my truck run the way it does?
« Reply #22 on: April 26, 2012, 06:59:43 am »
     So does that mean it is there, but just pushed in the grommet ?  If so you are welcome, that is what we are all here for, just to help without judgements. ;D
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline rusty but trusty

  • Newbie
  • Posts: 54
  • Newbie
Re: why does my truck run the way it does?
« Reply #23 on: April 26, 2012, 03:30:47 pm »
the pcv was pushed into the valve cover so bake74 saved the day.
does anybody have any idea why the engine would shake more than is reasonable at idle, the throttle response isn't great either
Logged
87 GMC V1500 305 700R4 NP208 and 10 bolts front and rear

Offline 454Man

  • Senior Member
  • ****
  • Posts: 1027
  • Why Race?
Re: why does my truck run the way it does?
« Reply #24 on: April 26, 2012, 03:36:51 pm »
Hook up a vacuum gauge and that will let us know what it reads. They are cheap to buy. I keep one hooked up inside my cab.
Logged

Offline Donut

  • Frequent Member
  • **
  • Posts: 402
Re: why does my truck run the way it does?
« Reply #25 on: April 26, 2012, 04:54:36 pm »
Misfiring or crossed plug wires?  Incorrect timing?  Spark plugs loose?  Distributor cap not locked down?
Logged
'73 Chevy K-20 ***SOLD***
350/tbh350/np205
My plow was half price if i took the truck with it.

'86 C-30 dually, 454/tbh400

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: why does my truck run the way it does?
« Reply #26 on: April 27, 2012, 05:43:27 am »
Quote from: rusty but trusty on April 26, 2012, 03:30:47 pm
does anybody have any idea why the engine would shake more than is reasonable at idle, the throttle response isn't great either

Quote from: Donut on April 26, 2012, 04:54:36 pm
Misfiring or crossed plug wires?  Incorrect timing?  Spark plugs loose?  Distributor cap not locked down?

     Also, check the motor mounts to see if they are shot.
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline rusty but trusty

  • Newbie
  • Posts: 54
  • Newbie
Re: why does my truck run the way it does?
« Reply #27 on: April 28, 2012, 03:28:22 pm »
OK i have 17 inches of vacuum and the plugs, plug wires and rotor and cap are brand new the cap is tight and the coil is a month old also # 1 is always wet but defiantly has spark
« Last Edit: April 28, 2012, 04:09:58 pm by rusty but trusty »
Logged
87 GMC V1500 305 700R4 NP208 and 10 bolts front and rear

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: why does my truck run the way it does?
« Reply #28 on: April 29, 2012, 12:00:02 pm »
      Not that is has any thing to do with the truck shaking, you said #1 spark plug is always wet.  With oil or just moister ?
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline rusty but trusty

  • Newbie
  • Posts: 54
  • Newbie
Re: why does my truck run the way it does?
« Reply #29 on: April 29, 2012, 07:49:27 pm »
wet with gas and #8 was also wet with gas  so i switched them but i think iv just lost my firing order completely
« Last Edit: April 29, 2012, 07:57:35 pm by rusty but trusty »
Logged
87 GMC V1500 305 700R4 NP208 and 10 bolts front and rear
Pages: 1 [2] 3   Go Up
« previous next »