« previous next »
Pages: [1]   Go Down

Author Topic: temp and oil pressure gauges not working  (Read 2531 times)

Offline mikesantos

  • Newbie
  • Posts: 15
  • Newbie
temp and oil pressure gauges not working
« on: February 13, 2013, 12:23:19 am »
when I bought my truck about a week ago, the temp and oil gauge are not working.  they just sit there.  where would I begin to diagnose the problem? kind of a newbie at this.  thanks ya all
Logged
--
Coleen - 1995 Cheyenne
Amber - 1983 - C10 Custom Deluxe

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: temp and oil pressure gauges not working
« Reply #1 on: February 13, 2013, 10:33:02 am »
     There is a thread on checking the gauges in the tech section by bd I believe.  You can start there, then I would check the sending units to make sure both are good and possibly that they are indeed hooked up and the wiring is good ( not shorted or cut, etc. etc ).
Logged
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline andystaiger

  • Newbie
  • Posts: 8
  • Newbie
Re: temp and oil pressure gauges not working
« Reply #2 on: February 13, 2013, 06:44:58 pm »
Considering everything is hooked up properly and you have electric sending units; You can just take a wire and ground out your sending units..
If they top out; then your sending unit is bad..
Otherwise it's your gauge.
Logged
Pages: [1]   Go Up
« previous next »