« previous next »
Pages: [1]   Go Down

Author Topic: MSD Digital 6 AL Box... (New)  (Read 3438 times)

Offline 454 Camper Special

  • Newbie
  • Posts: 31
  • Newbie
MSD Digital 6 AL Box... (New)
« on: June 27, 2015, 01:06:48 pm »
MSD Digital Multispark 6 AL Box.. New out of box.. Paired with a MSD Pro Billet HEI Distributor.. Upon ignition on.. 5 led light flashes..tried starting..now absolutely nothin..!! Trouble checked wiring..to factory specs..all good there.. I'm grounded to body..tight..to bare metal.. Any ideas folks.!? Shout back with any insight..! Appreciated

Sent from my SCH-S968C using Tapatalk

Logged

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6600
Re: MSD Digital 6 AL Box... (New)
« Reply #1 on: June 27, 2015, 02:07:53 pm »
In your previous thread, 383 Chevy Stroker, you indicated you had a bad ignition module in the MSD distributor.  Did you replace the module?
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline pneuner750

  • Newbie
  • Posts: 37
  • Newbie
Re: MSD Digital 6 AL Box... (New)
« Reply #2 on: July 08, 2015, 02:55:39 pm »
I had sort of the same problem. I was told  to tie the ground directly to the battery. I did, it worked. Hope this helps

Sent from my SM-P900 using Tapatalk

Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19174
Re: MSD Digital 6 AL Box... (New)
« Reply #3 on: July 08, 2015, 07:49:42 pm »
Why don't you post some pics of your setup and the wiring diagram?
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline pneuner750

  • Newbie
  • Posts: 37
  • Newbie
Re: MSD Digital 6 AL Box... (New)
« Reply #4 on: July 09, 2015, 03:09:53 pm »
I'll try to tomorrow

Sent from my SM-P900 using Tapatalk

Logged

Offline pneuner750

  • Newbie
  • Posts: 37
  • Newbie
Re: MSD Digital 6 AL Box... (New)
« Reply #5 on: July 17, 2015, 05:21:59 pm »
Is it possible the wires under the distributer cap are not insulated from each other. Make sure they can't ground out.

Sent from my SM-P900 using Tapatalk

Logged
Pages: [1]   Go Up
« previous next »