Front Bumper

[JasonD45]

I got to design a front bumper at work, and had it test fitted. Finishing up some welding, than paint, it will be semi perminant, until I get a winch and complete modifications and most likely powder coat. Would love to hear some opinions.

[LTZ C20]

It's huge, that's for sure.

[1967KaiserM715]

I got to design a front bumper at work, and had it test fitted. Finishing up some welding, than paint, it will be semi perminant, until I get a winch and complete modifications and most likely powder coat. Would love to hear some opinions.

Thinks it's tall and hangs a little low, I would have made the face only as tall as the "D" brackets, and maybe angle the bottom a little more. Just my 2 cents. Otherwise I do like the overall design


Sent from my iPhone using Tapatalk

[Engineer]

I like it as is. If you build another one I'll put it on my monster truck. Definitely has that boss appeal.

[Irish_Alley]

one good thing about building a custom bumper it will apeal to some and not to others. i like the design of it need more pictures to see the true fit. so far it does seam like a good bumper that will protect the truck

[fitz]

[/quote]
Thinks it's tall and hangs a little low, I would have made the face only as tall as the "D" brackets, and maybe angle the bottom a little more. Just my 2 cents. Otherwise I do like the overall design


Sent from my iPhone using Tapatalk
[/quote]

  This could be a great bumper for the states that measure bumper height as a way to regulate lift kit laws.
  Forum member Mike Phillips recently got pulled over in Florida for a bumper height violation.
  This bumper (with a matching rear bumper) could be an attractive solution to the problem.

[JasonD45]

The truck is lifted 8", so I was going for a big bumper. I plan on adding a winch into the bumper, so you would only see the rollers on the bumper. I didn't use the original brackets either, it's now bolted straight to the frame via 1/2" plates. Once I get the finished product I will share more photos. I was pretty close on my measurements.

[JasonD45]

Thank you all for the input though! I appreciate it.

[80Chevy4x4]

How much does it weigh?

[JasonD45]

I don't know, it had some weight for sure! But with two people lining it up, it wasn't to bad at all, I'd say around 80 pounds, if I had to take a guess. But it was missing the light brackets and lights, as well as two small panels. So when complete it might be around 100ish? It's all 10 guage steel

[Engineer]

Are you going to make more?

[80Chevy4x4]

Where do we place our order?