« previous next »
Pages: [1]   Go Down

Author Topic: Driveshaft Help  (Read 4332 times)

Offline buter1ma

  • Newbie
  • Posts: 44
Driveshaft Help
« on: December 22, 2019, 01:15:37 pm »
I have a 86 C10 long bed with two piece driveshaft. I am going to swap in a 700R4. Will I need to go to a one piece or what length from trans to center support bearing do I need?
Logged

Offline Irish_Alley

  • Tim
  • Senior Member
  • ****
  • Posts: 13333
  • Family is not an important thing. It's everything.
Re: Driveshaft Help
« Reply #1 on: December 24, 2019, 08:21:09 am »
depending on what trans/tail shaft you have now you may or may not have to do anything
Logged
If you can’t tell yourself the truth, who can you tell it to?~Irish_Alley

When you have eliminated the impossible, whatever remains, however improbable, must be the truth ~Sherlock Holmes

Offline buter1ma

  • Newbie
  • Posts: 44
Re: Driveshaft Help
« Reply #2 on: December 24, 2019, 09:25:04 am »
Its is a three on the tree manual transmission. I believe the length will have to change.
Logged

Offline JohnnyPopper

  • Senior Member
  • ****
  • Posts: 2773
  • Old Goof
Re: Driveshaft Help
« Reply #3 on: December 26, 2019, 03:25:14 pm »
I doubt your 3-speed is 30" long, but I have seen some with a long tail section.

Is the output shaft the same in size/splines? May not be...
Logged
1957 Apache 3100 235 Inline 6, 3 on the tree
1973 C-20, 3+3 454 4BBL TH400  Water Injection
1978 K-10, 350 4BBL TH350 NP203 M.M. Part time Kit/Hubs
1980 C-10 under construction

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19210
Re: Driveshaft Help
« Reply #4 on: December 27, 2019, 08:30:34 am »
Use this website as a tool and to find an inexpensive option. Use a one piece shaft.

http://www.car-part.com/cgi-bin/search.cgi
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠¯¯¯¯¯'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10
Pages: [1]   Go Up
« previous next »